FORD RANGER TiG Welded Heavy Duty 2mm Alloy Weather Proof Tool Box, With Rubber Seal & Gas Strut, Lockable Door Latch with Triple Latch Points, Suits and Fits into FORD RANGER XLS XLT Dual Cab, Comes with Stainless Steel Turn Buckles, Hooks and Tabs that allows the tool Box to Securely Anchor in without Drilling Any Holes, Once installed. Tool Box Is Very Secure Held in by 4ea x Included Stainless Steel Turn Buckles anchored in to Existing FORD Tie Points and Does not move, Main Tool Box Dimensions 1393mm Wide Left to Right 552mm High 565mm Deep from Front to Back Largest Compartment Dimensions 765mm Wide 560mm Deep with 474mm Entrance through top 530mm High 2nd largest Compartment Dimensions (Will Securely fit Several Cartons of Beer in this Section) 323mm Wide 560mm Deep with 474mm Entrance through top 530mm High Unit fits in and Door Opens fully Up with Existing Alloy Roll bar Inside Divided into 4ea x Sections, Large Section allow a standard 46L ARB Fridge or Suit Cases, Next Largest Section allow Tools, Straps, Ropes or a Small Suit Case or Valuable Shopping Etc Etc to be withing Drivers Reach on RHS and then there is two Sections above Wheel Well on each side with 1'' rib to stop things falling down into middle Section. Lid is reinforced and Designed and Built and Welded by Qualified Welder / Air Craft Fabricator $1,800+Gst 1/4 Turn Flush Mounted Lockable Door Latch is Offset to RHS to Allow Driver to Undo Door Latch from Standing on Ground, Once Unlatched Top Lid Automatically Raises via Gas Strut, This Alloy Tool Box is Solid As, You Could Jump up and Down on top of it without any issue, You Will not be disappointed by Its Strength, Design or Build Quality. Even has a Tie Anchor Point in the Rear External Side in the Center For the Dog to be Chained Up :) Freight Via TOLL IPEC Road Express Can be arranged Nation Wide at additional Cost